
Originally Posted by
stwsyb
I want to actually confirm that the injector is stopping to inject fuel at the time when I say it should via the software. Example bottom dead center on induction stroke.

Originally Posted by
Holley EFI Software (Engine Parameters)
Fuel Injector Information - End Angle
• This is the crankshaft angle in degrees when the injectors will finish their injection event. A value of “0.0” degrees will end the injection event at BDC (bottom dead center) before the compression stroke. A negative value moves the event before BDC and a positive value moves the event after BDC.
• Setting this to zero results in the injector firing ending at 0 degrees BDC on the compression stroke. There could be some improvements in cylinder to cylinder fuel distribution by tuning this parameter. If modifying, it is best to move this value in a negative direction to start.
http://www.motec.com.au/forum/viewto...p?p=3583#p3583 (Good technical description from Motec.)
http://forums.holley.com/showthread....m-Sensor-Setup (Magnetic & Hall-Effect Crank/Cam Sensor Setup)
May God's grace bless you in the Lord Jesus Christ.
'92 Ford Mustang GT: 385" SBF, Dart SHP 8.2 block, TFS TW 11R 205 heads, 11.8:1 comp, TFS R-Series intake, Dominator MPFI & DIS, 36-1 crank trigger/1x cam sync, 160A 3G alternator, Optima Red battery, A/C, 100HP progressive dry direct-port NOS, Spal dual 12" fans/3-core Frostbite aluminum radiator, Pypes dual 2.5" exhaust/off-road X-pipe/shorty headers, S&W subframe connectors, LenTech Strip Terminator wide-ratio AOD/2800 RPM converter, M4602G aluminum driveshaft, FRPP 3.31 gears, Cobra Trac-Lok differential, Moser 31 spline axles, '04 Cobra 4-disc brakes, '93 Cobra booster & M/C, 5-lug Bullitt wheels & 245/45R17 tires.