Street Avenger: Replace fuel bowl brass sight plugs with sight windows?

[IstoT]

Howdy. I'm buying a Street Avenger 670 from my friend. That carburetor don't have sight windows, just those brass plugs and I'd like to have windows version. Can I change those brass plugs to sight windows afterward? If that can be done, I'm planning to do that before I install the carburetor on my engine.

I found these sight windows. Are these working on Street Avenger
FUEL BOWL SIGHT WINDOW KIT SERVICE PART Fuel Bowl Sight Window kit (For Fuel Bowls 34-37 & 34-38) PART# 26-112
https://www.holley.com/products/fuel...s/parts/26-112. Best regards, Isto

[Gaz64]

That's not a screw-in for in place of the early level plugs. You could have your bowls machined for that sight gl**** but if might be easier to go for an off-the-shelf conversion like this:
https://www.holley.com/products/fuel.../parts/134-71S. Gary

[IstoT]

Thanks Gary. Seems that it was not so easy as I thought, so should be better stick on brass plugs. Someday when I do repair, then I could made this. I understand that you don't need to change fuel level so often that it won't bother too much.

[Gaz64]

Yes, that's correct. I mark one flat on the adjusting nut. Once the float level is correct, you can wind it up or down a flat at a time without removing the plugs.