Holley Dominator & Racepak SmartWire questions.

[Wendteb]

I'm making a list of items to purchase for my build. I plan on running the Racepak SmartWire, along with a Holley Dominator, and a Holley dash. But I have a few questions. I've looked through the manuals for the Holley dash, Dominator, and SmartWire, but there is just a lack of information when using these items together (unless I missed something).

- What is required to connect the SmartWire VNET CAN to the Holley? I have found a discontinued CAN connector kit, but I'm coming up a bit short on how these interface together.
- Can I output signal via Vnet to the SmartWire from the Dominator, and use that as an input, instead of/in addition to using the Racepak switch module?
- With a CAN connection, will I be able to see data from the SmartWire through the Holley dash, or datalog information if desired? Any input on this is much appreciated, Thanks, Eric

[Wendteb]

For anyone else wondering, I called the tech line. After a couple guys there had a conversation I found all the information I've been looking for between Dominator and SmartWire CAN communications. I'm updating this for anyone else wondering.
- Universal EFI module still required to connect the two together due to communications.
- The CAN connection really only allows the SmartWire to see sensor data, and use that to toggle items on & off.
- Cannot send an I/O output to the Smartwire from the ECU to use as an input.

[admiral_peck7]

Going to add to this for those searching, you can do manual I/O between the Dominator and the SmartWire, but you'll use Inputs or Outputs up on them. AFIK, there's still no way to do I/O through the CAN Bus network.