Hello. Some background: I'm trying to purchase the Terminator TBI package & Pro Dash and use this combination to control some extra outputs. This is going to be used for an Ultra4 race rig.

I'm trying to figure out:
Radiator Fan #1 On when Temperature is above 180°F - (This can be done via HP ECU on Terminator System with built in harness - I'd run the output to switched power.)
Radiator Fan #2 On when Temperature is above 195°F - (This can be done via HP ECU on Terminator System with built in harness - I'd run the output to switched power.)

#1 Oil Cooler fan on when engine Oil Temperature above xxx°F.
#2 Oil Cooler fan on when transmission Oil Temperature above xxx°F.
Physical Warning Light on when any of the following occur (I think I can power this light right off the control power, right?)

For the oil coolers and warning light, can I program outputs on the Pro Dash to turn on if I wire up temperature sensing devices for oil temps? Is this possible?