Results 1 to 1 of 1

Thread: Setting up the HP V5 software for installation.

  1. 07-10-2019, 11:31 AM #1
    pbeck001@yahoo.com
    pbeck001@yahoo.com is offline Junior Member
    Join Date
    Jan 2019
    Posts
    3

    Default Setting up the HP V5 software for installation.

    I'm running a Terminator 550-400 on a 5.3L LS engine and I want to use the HP EFI upgrade to enable using a stand-alone wet/non-progressive nitrous system. I'm running a separate fuel supply and triggering system for the nitrous and basically need the software to pull timing when the system is activated. I've connected the terminal A on the input/output connector to the +12V power supply at the nitrous solenoid and then made the connection at Pin B12 on ECU connector J2B. Question: Does this sound correct and if not what changes would you recommend before I upload the new EFI software? Thanks.

    Comments anyone ??
    Last edited by pbeck001@yahoo.com; 07-13-2019 at 08:11 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Technical Support
Join us