Tweet
I have an IQ3 street dash that I just added the EFI CAN cable to my MEFI 5. After I plugged the cable into the data port on my computer and to the back of the dash, I was able to detect new sensors and now the EFI data shows up on my data link software page, and also I can select the EFI sensor on the dash configuration page. But after sending the new configuration to the dash, the dash just displays zeros. None of the EFI information will display? I hope you can tell me what I'm doing wrong. Thanks.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.
Comment