Today I was setting up a channel condition where I wanted it to delay the on and off and set the values accordingly, sent config and then tested.
Now as you can see I set the RPM above 2000rpm to enable to channel but as soon as 2000rpm was past it turned on the channel, but with the "true delay" set to 5 I would have expected it to wait 5 seconds before turning on the channel........??? Have I missed something ???
Also has the same result on the "False delay" side of things too, as soon as the RPM dropped below 2000rpm it turned off the channel..........
Now as you can see I set the RPM above 2000rpm to enable to channel but as soon as 2000rpm was past it turned on the channel, but with the "true delay" set to 5 I would have expected it to wait 5 seconds before turning on the channel........??? Have I missed something ???
Also has the same result on the "False delay" side of things too, as soon as the RPM dropped below 2000rpm it turned off the channel..........
Comment