So I downloaded the DataLink II software to start on the setup for my UDX dash. Once I ran the software it asked me to select the device to be programmed, I selected UDX. It then prompted me to "Insert License Disk". I bought the unit secondhand, all I got was the display itself. Is there a way around this, so I can properly setup my display pages?

My next question. I will be interfacing the UDX with my Holley Dominator ECU. I already have the proper cabling to interface the V-Net Bus with the Holley CAN Bus. Can I access the UDX dash to program it by simply hooking the USB from the Dominator ECU to my laptop or so I need to physically tee into the V-Net cable to be able to access it? I know it's a long post, thanks in advance!