Hello, I just added the components to the Atomic system to allow the system to control timing. I reset the system and updated to the newest versions. I have it all set up correctly and it seems to run fine. I haven't taken it out and driven it because of poor weather. Before the timing control install the system would start fine but it just wasn't running as good as I desired. Now, for cold starts, I have to crank it for 25+ seconds for it to fire. Once it's running its fine. I did notice that the hand held was showing 0 psi at key on. I hear the pump come on and pressurize the system but no pressure is displayed. Once running the fuel pressure is displayed and seems to work fine. I seem to remember the display used to show pressure at key on.

Thanks!