Tweet
I have the coputech dattamaxx logger with a 4 magnet ds sensor.
how do I go about wiring with this set up?
how do I go about wiring with this set up?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.
Comment