7531 to activate my 2nd stage of n20

[nossbc]

i have a question i have a 7531 in my car ,could i use it to turn my second stage of n20 on? and if so how would i wire it ?any skechtes?
my first stage is run with the nos15835b nos controller wich it works of ground ,so i couldnt use my micro switch since it works of ground right?
thanks in advanced:thumbup1::thumbup1:

[msdtech1955]

like this... but, shoot me a p/m ( email address() for a bigger copy

[nossbc]

here is how i currently have my first stage wired, i was wondering how could i activate my second stage of n20 with my 7531.
here is my email [email protected]
thanks in advanced

[nossbc]

Any help????:001_huh:

[msdtech1955]

email sent

[nossbc]

Thanks:thumbup1:

[nossbc]

so here is the sketch i did....is this right????

[msdtech1955]

so on the first stage ...you want the timer to turn on nitrous...and not when the trans brake is released.....

[msdtech1955]

and on the second stage ...you just want the second stage to be turned on just with the time switch feature on the 7531......

[nossbc]

On the first stage I want it to come on as soon was in let go of transbrake and progress it if necessary, second stage want it to come on time base thru 7531 box(delayed after transbrake is released )

[msdtech21]

You'll need to use a relay to kill the first stage while on the brake by opening the circuit. Then wire the second stage into the brn/wht wire. Set the onDelay at the time you want the nitrous to kick in at. Set on the onTime for the duration of the nitrous stage activation.

[nossbc]

Thanks....could I put a switch in the brown/white wire as a precaution to Turn it on and off, just in case as last minute change before a run??
Thanks :thumbup1: