7761 sample run

[msdtech1955]

bump to the top

[billybe]

msd 7730 and 7761

where can you find a graft thats showes traction control after you make a run with lines above the rpm and under rpm

[msd_admin]

Here is the file.

[rich roberts]

sample : 7761
[ATTACH]1933[/ATTACH]

[ATTACH]1934[/ATTACH]

If my race pak shows at 2 seconds my rpm was 8000 and my drive shaft was5000, where do I put my upper and lower limits on the 7761?

[msdtech1955]

make any passes ( recordings) yet?

[rich roberts]

make any passes ( recordings) yet?

YES, we have several race pak read outs

[msdtech1955]

any arc module recordings?

[rich roberts]

any arc module recordings?

No I just installed ,and have not even started the car

[msdtech1955]

unfortunately, the only why to program that ..is to make some passes ...
then use those graphs as a base line.

[rich roberts]

unfortunately, the only why to program that ..is to make some passes ...
then use those graphs as a base line.

So, based on the rpm curve that I have off the race pac,what curve do I program into the 7761?

[msdtech1955]

good read .

http://bangshift.com/bangshift1320/b...es-more-in-it/

[Seattle_Mike]

So, based on the rpm curve that I have off the race pac,what curve do I program into the 7761?

You can actually export the RacePak driveshaft log OR MSD Review log and import it directly into the ARC module programming screen so you can program your driveshaft curves against it.

[msdtech1955]

oh no,,,,,check your pm mike.

[pbi21]

How do you do that

[hydrotherapy]

7761

Why when in burn out in the 7730 is the rev limiter active in the 7761:sad: