when you activate the burnout limter ( light blue wire)..it only follows the
rev limit ....
the arc (7761) only activates after the dark blue wire is released from 12 volts ( launch limiter engaged) and it sees drive shaft speed.
when you activate the burnout limter ( light blue wire)..it only follows the
rev limit ....
the arc (7761) only activates after the dark blue wire is released from 12 volts ( launch limiter engaged) and it sees drive shaft speed.
Junior Member
7761 sample run
thats not in the case of public enemy, i think every tune they did had a sample from somewhere
:confused1::confused1::confused1::confused1:
Junior Member
In the sample runs provided by msdtech 1955, the d/s curve starts with a point at (0,15000). Why is that?
Posting Permissions
Reply With Quote