custom drawings

[msdtech1955]

and where are you using those solenoids?

the controller ...takes the load on the nitrous solenoids....
so i assume , you wanted to use those in line?

more info would help (

[mcat]

and where are you using those solenoids?

the controller ...takes the load on the nitrous solenoids....
so i assume , you wanted to use those in line?

more info would help (

the progressive box runs through the solenoid grounds. the relays will be for the hot side of the solenoinds when the system is armed..

[msdtech1955]

this is the drawing....they gave you right?
edelbrockni.jpg

[mcat]

this is the drawing....they gave you right?
Attachment 2055

that does appear to be it, .
can you draw me up the way you would do it..
i have a relay activated by the activate lead off the eddy box to make my possitives on the solenoid hot. that way the eddy box is not powering the hot side of the solenoids

[flight71]

Looking for a diagram using 7220 ignition box, 8982 start/retard controller to retard the timing for the nos and the start retard, a 8950 RAS, 8737 3step, and 2 8961 relays. I am wanting to turn the nos solonoids on and retard the timing, at the release of the trans-brake button. Any help greatly appreciated!

[Smalls&7]

Is this still going on?

[whisnane]

I need a drawing for wiring the following. msd 6 digital plus, 8969 msd window switch,2 pin fuel pressure safety switch, transbrake,nx 2000 nitrous controller, using 5 pin relays,also using 3 pin wos on carb.,single stage nitrous. Thanks in advance for your help. Whisnane

[timbowling_000]

I was wondering if you guys could get a diagram for power grid with power module as a progressive, to where the transbrake will interrupt and not activate noids? Also have a tps if I could use that instead of WOT switch?