-
custom drawings
:thumbup1:first post .... if your looking for some help with a drawing in a nitrous application (digi-set-relays-retards) :001_cool:..this would be the place... dont be afraid to ask .
i'll start off with this normal one.
2_step_nitrous_latching_relay 7531.JPG
-
another custom drawing link.
-
What diagram would be the best for my application, Im running a single stage plate and a bang button, 6al box, transbrake, and now a 8975 timing controler. What would be a good diagram to wire it so that when im on the trans brake, the motor is still at full timing, and the solenoids are disabled, and when I release the trans brake, it pulls timing, and enables the nitrous . I know it will end up going through relays, and I have them, just need a little info. Thanks fellas
-
do you wish to use timers?
-
No, I won't be using timers at this moment. I'm figuring I will be using the first 3 stages to pull the amount of timing that I need. I think I will set the engine at 34* and pull anywhere from 10 to 12*. Thanks again!!
-
drawing it up right now... also p/m me your email address ...so you can see it bigger :thumbup1:
-
-
-
-
nitrous application can you draw this up? relays and all. i will be using heavy duty golf cart continuous duty (ford starter type) relays for my nos/ fuel solenoids and regular 30 amp for the trans brake .. i think
grid 7730
box7720
coil 8261
box 7751
and edelbrock 79100 progressive
WOT switch
i need a revlimiter while on the trans brake
i want full timing until transbrake is released then initial timing dump to 11-15 total from 34-36 then i want to be able to map the timing with the grid.
i think thats what i want what do you think?:lol:
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Junior Member
Reply With Quote