Tweet
Just installed some Earl's 3/8" Stat-O-Seal crush washers on my banjo bolts and I'm wondering if anyone can help me with the recommended installation torque? My copper crush washers were leaking, so I've gone to these Stat-O-Seal crush washers in hopes that they will seal. I believe the factory recommended torque value from the factory specs is 30 ft/lbs for copper crush washers. Would it differ using the Stat-O-Seals? They're aluminum vs copper.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.
Comment