I'm using my original fuel rails from the 950 Commander MPFI for my SBC Gen I motor.
I'd like to add a transducer to monitor fuel pressure.
My original fuel rails came with one fitting with a port where the Schrader valve was installed.
I'd like to buy another just like it, to install on the rear of the engine to connect the wire to.
Is this part available separately? I believe this is similar, but no port for a auxiliary fitting:
https://www.holley.com/products/fuel...parts/9906-127
Thanks. Tim
I'd like to add a transducer to monitor fuel pressure.
My original fuel rails came with one fitting with a port where the Schrader valve was installed.
I'd like to buy another just like it, to install on the rear of the engine to connect the wire to.
Is this part available separately? I believe this is similar, but no port for a auxiliary fitting:
https://www.holley.com/products/fuel...parts/9906-127
Thanks. Tim
Comment