Results 1 to 3 of 3

Thread: Excessive fuel in bowl area when warm, right after initial acceleration, flood stalls

  1. #1
    jinaeve Guest

    Unhappy Excessive fuel in bowl area when warm, right after initial acceleration, flood stalls

    After acceleration, it seems to flood then stalls out. I have a Holley 80511-1 that seems to be blowing fuel out the bowl area after acceleration from a stop when the engine is warm. I checked float levels and idle mixture screws but can't seem to figure this one out. It all worked fine before I had the vehicle dyno'd but hasn't been the same since. Thoughts, recommendations would be very welcome. I just need some ideas before going back to the dyno guys.

    Thanks!
    Last edited by jinaeve; 03-19-2011 at 09:00 PM.

  2. #2
    91camaro248 Guest

    Default

    how old r the needle n seat's???? might wanna throw some new 1's in. how much psi r ya running???

  3. #3
    rickyr Guest

    Default

    HI,
    I would check the fuel level
    Remove the fuel bowls and hold them upside down and level
    and bend the tang on the float so the float is level across the center of the bowls
    thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us