Ground switch datalog activation not working.

[Blownstatesman]

That's awesome, thanks mate. I'll give it a try and let you know how I go!

[Blownstatesman]

After running a heap of tests, it turns out that there is a connection fault somewhere in either the main harness or at the ECU terminal connection for J1-A4. Switch activation works fine on the other inputs, so it just happened to be that I picked the faulty input to try first with the datalog. Thanks very much for your input Danny, it's greatly appreciated! Cheers!

[Danny Cabral]

After running a heap of tests, it turns out that there is a connection fault somewhere in either the main harness or at the ECU terminal connection...

It's most likely in the main harness. Unplug the ECU connector, and perform an Ohm's continuity test on that wire.

Thanks very much for your input Danny, it's greatly appreciated! Cheers!

You're welcome.