23 results in 0.0124 seconds.
-
Turbo 302 won't run properly.
My car seems to run fine until it warms up to operating temperature, then it begins to surge, stall, misfire, and everything else it can possibly do....Starts07-08-2023 11:00 PMEnds07-09-2023 11:00 PM -
Holley 3 bar not reading boost.
The car is a1990 Ford Fox body, 306 Vortech V1 12 psi, Comp Cam, Trick Flow intake, 185 AFR cylinder heads. Running a Terminator X. When trying to do... -
ACDelco MAP sensor for LS3 crate engine.
Hi all. I have an LS3 crate engine which has the standard MAP sensor that it came with - ACDelco part #55573248. I have a Terminator X Max I'm going to... -
Fuel pump shut off after prime.
Trying to fire my LSx swapped S10, running Terminator X on a 5.3L with CPW integration harness. When I key on, the pump runs for the five second prime... -
SBF Terminator X Max - Hesitation off the line and at low throttle shifts.
Hello everyone, and thanks to anyone that decides to help.
I'm having an issue that I cannot correct. When I give it more throttle than... -
Bosch LSU 4.9 WBO2 Sensor & Wiring Problem
The thread for WBO2 sensors (at the end of this sentence) is not much help because I think the wiring diagram for the ECU is wrong or there's something... -
AFR jumping around at startup, then dies 5.3L LS.
I have installed the Terminator X on a 5.3L LS. Has a high lift cam, but all fairly stock. Engine has about 1000 miles on it. Has started to either... -
Mapping blinkers to 7" Digital Dash?
Hello. Brand new Terminator user. I searched and saw some similar information in this forum, but not my exact situation. I watched every video I could... -
Help trying to obtain vehicle wheel speed.
I have a boosted LS swapped 240SX with the Holley Terminator X and a 300ZX transmission. I'm trying to setup Boost By Gear and perform dyno tuning, which... -
Which version for Gen 3 LSx, ProCharger?
The title says it all there. I'm using version 1, just wondering if I'm missing something in version 2. The only bit of details I found said Version 2...Last edited by Nbrooks; 07-05-2021, 12:36 AM. -
CAN IO Module 554-165
Just received this module and I want to set it up. For Terminator X it states it requires V2 Build 51 & up, and I'm only finding 50 on the website.... -
Terminator X & On3 turbo kit, SBF?
Hello, I have a few questions. 1) Will the Terminator X support a Turbo? 2) What's needed to run a turbo with the Terminator X system? -
'94 Mustang Terminator X Water/Meth ICF
The Water/Meth ICF is not in my drop down menu under the add ICF tab. Is there a way to add it to the Holley EFI software? -
Rolling Antilag
How do you setup rolling antilag in a Terminator X? I don't see Rev Limiter #1 in the setup table type. 2500 RPM at a 60 MPH roll is what I'm trying to... -
Accel Fuel Injectors
I have a set of 19 lb/hr Accel injectors that I'm trying to use with the Terminator X ECU. Are these the same as the Holley 19 lb/hr or will I need to...