13 results in 0.0096 seconds.
-
Error 29
I was updating my Terminator firmware to version 40100 with a 3.5" touchscreen. All was going fine. When it went to upload the BAM header the 3.5"... -
V5 Build 171 Skip/Misfire
Another V5 Build 171 skip story. The specifics: Flying Magnet, Hall-Effect crank trigger, Magnetic cam sensor, COP ignition. Loaded V5 Build 171 (latest... -
Data does not exist - GCF Wizard
Hello all. I've recently installed this Terminator Stealth EFI Kit: https://www.holley.com/products/fuel...tor_efi/termin... -
New to the Terminator with tuning issues?
Hello all, great forum. I'm new to the whole EFI set up and of course when I stepped into the EFI world I had to go big and did the Holley Terminator... -
Terminator/HP and AFR gauge(s) connection?
I have found a few posts pertaining to my question, but they all differ slightly and don't match up to what I'm looking for.
So my question... -
Terminator Analog Gauges Issue
Quick question. Hopefully someone can assist me. I'm running a Terminator setup on a SBF. Trying to get three analog gauges working (water temp, fuel... -
Log #0 Customer Service/Support With Terminator ECU
I have the Terminator 550-405K system. The files were erased from the SD card unit. I downloaded files back to SD card and powered the vehicle. Searching...Last edited by HKvan; 03-10-2018, 05:25 AM. -
Misinformation Heads Up
First off Holley does have great customer service, but I do have some information to give as a heads up. I contacted a Holley rep and was left without... -
Slow Down Surge/Idle Surge
I have installed and have been driving my '70 Mustang that has the Terminator EFI full kit - fuel & everything.
I had horrid issues on... -
Error Message On Holley Terminator EFI Screen
Just about every other time I crank my car, I get the first screen and it will just sit there for about 30 seconds, then it will flash up an error.... -
Terminator EFI - Bogs Going From Idle To Sudden WOT
Hi all - any input is welcome. The system is running well overall, and I've been making minor adjustments. One thing that's not doing so well, is the... -
Clogged Billet Fuel Filters
I have a question regarding whether a 162-550 10 micron fuel filter is cleanable? Had a billet pump go bad, and Holley replaced it, but not the filter.... -
MAP Sensor Status "HEr"
Just completed installing the Terminator EFI in my '67 Camaro.
Initializing went fine and system status is OK.
However the MAP sensor under...
