36 results in 0.0155 seconds.
-
Terminator X Max Gen III Hemi
Aloha! I'm in the middle of swapping the Front Cradle, Rear Cradle, Engine, transmission, driveshaft, and exhaust from a 2006 Dodge Charger SRT8 into... -
Sniper Swap To Terminator
Hi guys. I currently have a Sniper EFI with a Sniper HyperSpark ignition setup. ECU is blown and I'm thinking of replacing it with a Terminator EFI. Question... -
Throttle blade shaft play. Can it be repaired?
I have this Terminator EFI throttle body with a loose shaft for the primary throttle blades. Is this normal? https://youtu.be/X9ksFFf1G-o. It doesn't... -
Can oil contamination damage the MAP sensor?
Main questions: Is it normal to see an oil film on the 554-120 MAP sensor after removing it from the Terminator throttle body? Will that oil damage the... -
HP Wideband O2 Reading Rich?
I recently installed a 2x4 Terminator Stealth system on a SBC equipped with a Cross-Ram intake. Prior to installation, I was running an Auto Meter wideband... -
What on earth!
So I'm looking for some guidance because I've done everything under the sun trying to see what I can find.
Background:
Freshly built... -
Bigger injectors - SBC stroker 427?
My Terminator EFI worked great with my SBC 383, but I was able to acquire a Dart little "M" 427 with Cali guts. With AFR 220cc heads and the... -
Terminator X, No RPM Signal
Fresh install of Holley Terminator X on a 1UZFE with K24 Coil-On-Plug. Engine has a 60-2 crank trigger wheel with magnetic pickup. On handheld I'm not... -
LQ9 Backfire through exhaust won't idle initial startup
Finally finished up my build and installed the Terminator X for LS1/LS6 on my freshly rebuilt LQ9. It has a Comp Cams NSR drift cam. Stock height push... -
Pedal & throttle body not communicating.
I have the Terminator X Max DBW system for a Gen 3 Hemi. I have everything wired and hooked up, and I think it's all correct. I went through the initial... -
Circuit & Relay Sanity Check
Terminator 4BBL, Dual Sync, CNP. I'm retrofitting a Terminator EFI 4BBL system into a 1971 Ford.
I'm using the factory harness and running a couple...Last edited by gmtech13; 10-19-2020, 10:40 AM. -
Holley EFI Terminator LSx "Miss" Issue/Crank Pos Reading Weird
I've been chasing down a "miss" for over a month now. I've contacted Holley with no avail and am still trying to get in touch with someone... -
Terminator 4BBL EFI on SBF & Coil-Near-Plug Options with Dual Sync.
I have a SBF 347 that will be getting a Terminator 4BBL TBI EFI system soon. I purchased a Dual Sync Distributor and originally planned to run LS D585... -
Terminator With CNP
I've purchased a Terminator EFI system (550-406K) with complete fuel system back in '16 during the Christmas holiday. Fast-forward to fall of 2019 and... -
Terminator or Sniper?
I have the chance to buy a (barely) used Terminator TBI kit for $750. (Throttle body, ECU, and harness) is the old school Terminator kit better than the...