CAN Connection Confusion

[dannyual320]

Danny, I'm planning on using my stuff the way you are using yours, but just part time. I wanted to remove the 3.5" TSLCD touchscreen when I'm done...

[dannyual320]

Danny, I don't know if the Pro Dash is going to function without the terminator plug. I've only powered up the Pro Dash once and that was accidentally....

[dannyual320]

As I said, I don't plan to normally have the handheld device in the car, therefore the male end of the CAN extension harness will be just sitting there....

[dannyual320]

I'm getting very confused; kind of like going in circles with my eyes spinning around. I have a Dominator ECU and the 12.3" Pro Dash. The Pro Dash...

[dannyual320]

I thought I'd post this picture that I took yesterday (12 Jan 2023) afternoon. It was an accidental Pro Dash power up. I was powering up...

[dannyual320]

Here's a picture that I keep. It's from four years ago and sometimes when I'm showing friends or coworkers pictures of my LS3 swapped Fox...

[dannyual320]

Thank you for the confirmation, Danny. Because I've never actually worked with the Pro Dash and Dominator other than physically installing and wiring...

[dannyual320]

I just remembered I don't have the stand-alone 12.3" Pro Dash. This Pro Dash has to be able to see Holley EFI ECU data, so I'm thinking that it gets...

[dannyual320]

Those pictures look like something out of a wiring horror movie!

[dannyual320]

I was always under the assumption that all of my sensor inputs to the Dominator could be sent to the 12.3" Pro Dash via CAN. However on page 15 of...

[dannyual320]

I have the exact same setup in my LS3 swapped, 1991 Foxbody Mustang coupe. I just recently (the day after Christmas) wired the turn signals into my Pro...