Home

[383_StealthRam]

It should be able to, see page 14 in the following: https://documents.holley.com/199r11760.pdf
4L60E, 65E & 70E are essentially the same transmission...

[383_StealthRam]

100% agree with AndyF.

[383_StealthRam]

If it spins, you really should still verify that it's pointing to the "correct tower" in the cap; as in set your #1 cylinder to TDC compression...

[383_StealthRam]

Glad you finally resolved the issue, and for updating the post. Good job!

I don't think there's a problem with the Walbro pumps per se, I've...

[383_StealthRam]

I noticed this also the other day, however, I went to the bottom and switched my theme to the Default vB5 Style, and to be honest it's a much better look...

[383_StealthRam]

Thanks for adding that ignition harness connector reference Danny! I meant to link to it in my post but forgot. I did that on my (Stealth Ram/TPI) harness...

[383_StealthRam]

Just for reference as it relates to these distributors, I recently inquired to Holley support about the difference(s) between the Holley and MSD branded...

[383_StealthRam]

Hi Bill, actually mines a SBC (565-100) 1st Gen Dual Sync I purchased back in Sept 2016. I ran it first for sequential injection with traditional cap/rotor...

[383_StealthRam]

Datalog when it's happening and also look at your TPS & MAP RoC channels to make sure you're not getting any % spikes that would kick you out of Closed...

[383_StealthRam]

Awesome, glad you got that squared away and thanks for updating this forum thread.

[383_StealthRam]

Personally, I'd do one last Transfer Learning To Base, smooth things out. Then lower your Closed Loop & Learn values to around 5%-8%. Then every...

[383_StealthRam]

[email protected]: Simply change the values in the tables from 50 (or whatever they are, sometimes they're 100) to your desired 3, 5, 10 or, however,...

[383_StealthRam]

See below. HTH


...

[383_StealthRam]

Unless I missed it I don't see that you provided your GCF tune file and actual datalog of the issue? In one post you did provide a datalog, however, in...

[383_StealthRam]

Did you or someone else recently change the Fan #1/#2 settings from the Basic I/O screen (under System ICF) over to the the more advanced/custom Inputs/Outputs...

[383_StealthRam]

I wouldn't think so provided you have the USB cable (CAN) to connect with laptop computer. That should all be covered in the instructions, or maybe take...