Page 1 of 74 1231151 ... LastLast
Threads 1 to 25 of 1831

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 8,626
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 17,310
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 5,562
    07-21-2017, 04:16 PM Go to last post
    • Replies: 2
    • Views: 12
    Today, 07:12 AM Go to last post
  1. Gas mileage terrible on new Sniper install.

    Started by Firebird, 08-11-2019 09:37 AM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 736
    Today, 01:12 AM Go to last post
  2. PSI/kPa

    Started by Jodirte, 08-19-2019 07:02 PM
    • Replies: 3
    • Views: 91
    Yesterday, 11:17 PM Go to last post
  3. Sniper EFI & Aftermarket Tachometer Question

    Started by hpiblitz144, 02-27-2017 09:01 PM
    • Replies: 6
    • Views: 1,973
    Yesterday, 05:37 PM Go to last post
  4. No crank signal on '63 Lincoln.

    Started by Mpinelli24, 08-19-2019 07:03 PM
    • Replies: 1
    • Views: 77
    08-19-2019, 11:00 PM Go to last post
    • Replies: 2
    • Views: 101
    08-19-2019, 10:54 PM Go to last post
  5. Vacuum port issue?

    Started by Riki, 08-19-2019 04:05 PM
    • Replies: 2
    • Views: 77
    08-19-2019, 10:39 PM Go to last post
  6. Acceleration Enrichment Settings

    Started by Mad Cadder, 07-27-2019 12:47 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 922
    08-19-2019, 06:59 PM Go to last post
  7. Sniper lb/hr in base fuel.

    Started by riche, 08-16-2019 05:42 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 342
    08-19-2019, 05:18 PM Go to last post
  8. Will not idle lower than 900 RPM without stalling.

    Started by rosco15, 08-11-2019 03:18 PM
    • Replies: 3
    • Views: 112
    08-19-2019, 05:10 PM Go to last post
  9. Minimum system requirements for Sniper software.

    Started by Leon82, 08-18-2019 09:11 PM
    • Replies: 4
    • Views: 80
    08-19-2019, 02:02 PM Go to last post
  10. Struggling and Stalling Under Load

    Started by Rebu1ltCJ7, 08-18-2019 01:33 PM
    • Replies: 4
    • Views: 105
    08-19-2019, 10:23 AM Go to last post
  11. Unhappy No start after moving Sniper to new engine.

    Started by tom8034, 08-18-2019 02:14 PM
    • Replies: 2
    • Views: 97
    08-19-2019, 10:20 AM Go to last post
  12. Returnless Fuel System

    Started by srcracing, 08-19-2019 04:12 AM
    • Replies: 3
    • Views: 95
    08-19-2019, 10:14 AM Go to last post
  13. Dual Tank Setup

    Started by TreyRouse, 07-08-2019 09:59 PM
    • Replies: 2
    • Views: 185
    08-19-2019, 05:14 AM Go to last post
  14. Magnetic Pickup MSD vs Sniper

    Started by Stan C, 08-11-2019 11:52 PM
    • Replies: 7
    • Views: 286
    08-18-2019, 09:26 PM Go to last post
  15. At wits' end with Sniper 4150.

    Started by JMcConn, 08-18-2019 12:20 PM
    • Replies: 3
    • Views: 135
    08-18-2019, 08:13 PM Go to last post
  16. Please help me understand my datalog. I have questions.

    Started by danford1, 08-12-2019 04:47 PM
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 632
    08-18-2019, 05:42 PM Go to last post
  17. Started initially, now no start.

    Started by jfj85, 08-18-2019 12:58 PM
    • Replies: 8
    • Views: 104
    08-18-2019, 05:22 PM Go to last post
  18. Need info on AFR readings.

    Started by Firebird, 08-17-2019 05:27 PM
    • Replies: 5
    • Views: 129
    08-18-2019, 02:20 PM Go to last post
  19. Changing displacement on an existing calibration?

    Started by Stian, 08-18-2019 11:32 AM
    • Replies: 3
    • Views: 60
    08-18-2019, 11:56 AM Go to last post
  20. IAC going crazy, warm idle.

    Started by gearhead927, 08-18-2019 11:14 AM
    • Replies: 0
    • Views: 47
    08-18-2019, 11:14 AM Go to last post
  21. Hooked up manifold vacuum advance, question.

    Started by Leon82, 08-15-2019 05:31 PM
    • Replies: 7
    • Views: 205
    08-18-2019, 09:41 AM Go to last post
  22. Base Fuel Tuning Help

    Started by Mad Cadder, 08-17-2019 08:14 AM
    • Replies: 6
    • Views: 178
    08-18-2019, 08:28 AM Go to last post
  23. Mislead

    Started by Stan C, 08-17-2019 12:37 PM
    • Replies: 5
    • Views: 174
    08-18-2019, 07:01 AM Go to last post

Page 1 of 74 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us