Page 1 of 87 1231151 ... LastLast
Threads 1 to 25 of 2175

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 11,790
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 22,424
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 8,420
    07-21-2017, 04:16 PM Go to last post
  1. Stalls when throttle applied in drive - idles good though.

    Started by 1969customS, 02-15-2020 08:30 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 176
    Today, 01:33 AM Go to last post
  2. Fuel pump pickup location.

    Started by RealWing, Yesterday 04:12 PM
    • Replies: 3
    • Views: 37
    Today, 12:01 AM Go to last post
  3. Odd behavior from ECU.

    Started by silver74vette, 02-08-2020 01:13 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 447
    Yesterday, 10:41 PM Go to last post
  4. Missing data points with engine not running.

    Started by limpsilver, 01-28-2020 11:04 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 338
    Yesterday, 10:38 PM Go to last post
  5. Initial fire-up help.

    Started by Mercury 100, 02-07-2020 01:42 PM
    • Replies: 6
    • Views: 221
    Yesterday, 10:12 PM Go to last post
  6. Need Help With New Install Startup - Datalog & Config Attached

    Started by norm209326, 01-07-2020 08:16 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 592
    Yesterday, 10:02 PM Go to last post
    • Replies: 1
    • Views: 25
    Yesterday, 08:16 PM Go to last post
  7. MSD 8598 Question - SBF

    Started by 67ModCoupe, 02-09-2020 11:39 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 253
    Yesterday, 06:50 PM Go to last post
  8. IAC goes high, when is Learning done?

    Started by TriplaneDave, 02-15-2020 11:03 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 192
    02-15-2020, 09:59 PM Go to last post
  9. Another thread about hooking up the TACH to the Sniper.

    Started by 1969customS, 02-06-2020 01:16 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 37
    • Views: 953
    02-15-2020, 09:10 PM Go to last post
  10. Dead ECU?

    Started by NAVY7797, 01-09-2020 08:05 PM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 910
    02-14-2020, 09:12 PM Go to last post
  11. Anybody making power with a centrifugal blower?

    Started by Tenhorse, 01-07-2020 05:26 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 733
    02-14-2020, 08:55 AM Go to last post
  12. 1990 454SS - TBI 220 to Sniper conversion.

    Started by Royal5, 02-11-2020 08:27 PM
    • Replies: 7
    • Views: 153
    02-13-2020, 10:38 PM Go to last post
  13. Dual Sync Distributor

    Started by chevyluv72, 02-09-2020 02:59 PM
    • Replies: 6
    • Views: 189
    02-11-2020, 03:06 PM Go to last post
  14. Can't Stabilize IAC

    Started by ScottAB, 02-01-2020 04:35 PM
    • Replies: 8
    • Views: 354
    02-11-2020, 12:36 PM Go to last post
  15. Has anyone replaced the Sniper injectors themselves?

    Started by danford1, 09-07-2019 11:33 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,367
    02-10-2020, 03:46 PM Go to last post
  16. Rich spike when coasting, then accelerating.

    Started by 86BKO, 02-09-2020 10:38 PM
    • Replies: 3
    • Views: 134
    02-10-2020, 12:33 PM Go to last post
    • Replies: 1
    • Views: 90
    02-10-2020, 03:00 AM Go to last post
    • Replies: 8
    • Views: 393
    02-09-2020, 12:09 PM Go to last post
  17. Off the shelf WBO2 sensor?

    Started by Devo898, 08-17-2019 10:47 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 1,538
    02-07-2020, 10:32 AM Go to last post
  18. Dead injector on Sniper.

    Started by Rtchaney, 09-19-2018 07:45 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 34
    • Views: 7,479
    02-07-2020, 10:30 AM Go to last post
  19. Cold start & warm up - rear cylinders excessively lean.

    Started by Flatlander, 02-01-2020 12:34 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 30
    • Views: 950
    02-07-2020, 12:22 AM Go to last post
  20. Exclamation Bad SD Card

    Started by tom8034, 02-06-2020 01:08 PM
    • Replies: 0
    • Views: 87
    02-06-2020, 01:08 PM Go to last post
  21. 2300 vs BBD vs 2GC for lower HP inline six.

    Started by JDSF, 02-02-2020 11:24 PM
    • Replies: 2
    • Views: 146
    02-04-2020, 07:03 PM Go to last post
  22. Sniper Blowing Fuses

    Started by Harveyd9, 06-11-2018 04:23 PM
    • Replies: 9
    • Views: 1,631
    02-04-2020, 01:47 PM Go to last post

Page 1 of 87 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us