Page 1 of 91 1231151 ... LastLast
Threads 1 to 25 of 2262

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 13,046
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 24,211
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 9,538
    07-21-2017, 04:16 PM Go to last post
  1. Popping at high RPM.

    Started by Ososexychevelle, Yesterday 01:50 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 294
    Today, 08:30 PM Go to last post
  2. Sniper XFlow Questions

    Started by Not_Available, 03-30-2020 09:24 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 63
    • Views: 1,048
    Today, 01:18 PM Go to last post
  3. Ignition Reference Angle

    Started by richie49, Yesterday 05:43 PM
    • Replies: 4
    • Views: 105
    Today, 08:02 AM Go to last post
  4. 350/700R4 Downshift Stall & Tuning

    Started by PiratesC20, Yesterday 03:07 PM
    • Replies: 2
    • Views: 61
    Yesterday, 06:59 PM Go to last post
  5. New Sniper install, runs perfect until it just stops.

    Started by stacked33, 04-03-2020 03:49 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 359
    Yesterday, 06:03 PM Go to last post
  6. Newbie that would like to learn.

    Started by mdille, 04-03-2020 05:23 PM
    • Replies: 7
    • Views: 146
    Yesterday, 01:06 PM Go to last post
  7. Refresh Sniper

    Started by mixman98, 04-03-2020 04:34 AM
    • Replies: 6
    • Views: 106
    04-03-2020, 06:15 AM Go to last post
  8. Issue going into WOT.

    Started by z2812b, 03-31-2020 09:55 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 279
    04-02-2020, 11:04 PM Go to last post
  9. Going lean after start.

    Started by 78 C10, 03-21-2020 09:11 PM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 587
    04-02-2020, 05:07 PM Go to last post
  10. Sniper clicks when starting.

    Started by JohnnyK, 04-02-2020 04:36 PM
    • Replies: 1
    • Views: 69
    04-02-2020, 04:52 PM Go to last post
  11. New Exhaust & Adjustment?

    Started by jc03, 01-27-2020 03:48 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 649
    04-02-2020, 04:38 PM Go to last post
  12. SBC Single-Plane Learn Table

    Started by thecowwatcher, 03-31-2020 09:19 PM
    • Replies: 5
    • Views: 144
    04-01-2020, 05:09 PM Go to last post
  13. Let’s talk about sticking secondaries.

    Started by BMWM.D., 03-30-2020 08:02 PM
    • Replies: 5
    • Views: 160
    03-31-2020, 12:46 AM Go to last post
    • Replies: 3
    • Views: 132
    03-30-2020, 02:51 PM Go to last post
  14. Timing control at low RPM cruise?

    Started by stinkfinger, 04-22-2019 04:00 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 1,771
    03-30-2020, 01:08 PM Go to last post
  15. Sniper Stealth & CD Ignition

    Started by Firebirdjones, 03-29-2020 10:06 PM
    • Replies: 9
    • Views: 165
    03-30-2020, 01:06 PM Go to last post
  16. Sniper Stealth IAC Motor

    Started by BMWM.D., 03-22-2020 03:19 PM
    • Replies: 4
    • Views: 135
    03-29-2020, 10:27 PM Go to last post
  17. Marine 454 IAC setting unknown variables.

    Started by Don Petrey, 03-17-2020 02:06 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 708
    03-29-2020, 01:58 AM Go to last post
    • Replies: 8
    • Views: 272
    03-28-2020, 11:05 PM Go to last post
  18. Fuel Supply

    Started by Stroked1966stang, 12-16-2019 01:33 PM
    • Replies: 7
    • Views: 522
    03-27-2020, 06:01 PM Go to last post
  19. Sniper Timing Control

    Started by Marks67caro, 03-27-2020 02:26 PM
    • Replies: 5
    • Views: 204
    03-27-2020, 04:53 PM Go to last post
  20. AFR goes wacko during cruise.

    Started by Johnret, 03-26-2020 06:27 PM
    • Replies: 5
    • Views: 183
    03-27-2020, 11:12 AM Go to last post
  21. Too much fuel on initial pump prime.

    Started by Jeff Parker, 03-24-2020 09:25 PM
    • Replies: 9
    • Views: 320
    03-26-2020, 07:30 AM Go to last post
  22. Is a generator system OK with Sniper EFI?

    Started by otterby, 03-25-2020 11:16 AM
    • Replies: 2
    • Views: 129
    03-25-2020, 02:06 PM Go to last post
  23. Fuel Pressure

    Started by bingo2, 03-25-2020 10:23 AM
    • Replies: 3
    • Views: 134
    03-25-2020, 10:55 AM Go to last post

Page 1 of 91 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us