Page 1 of 88 1231151 ... LastLast
Threads 1 to 25 of 2186

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 11,995
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 22,682
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 8,596
    07-21-2017, 04:16 PM Go to last post
  1. Add Timing Control

    Started by Crankshaft, Yesterday 10:30 PM
    • Replies: 2
    • Views: 24
    Today, 02:31 AM Go to last post
  2. Odd behavior from ECU.

    Started by silver74vette, 02-08-2020 01:13 PM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 793
    Yesterday, 04:56 PM Go to last post
  3. MSD 8598 Question - SBF

    Started by 67ModCoupe, 02-09-2020 11:39 AM
    2 Pages
    1 2
    • Replies: 19
    • Views: 476
    Yesterday, 03:40 PM Go to last post
  4. Idle Issue

    Started by Blkace32, 02-21-2020 05:49 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 301
    Yesterday, 03:13 PM Go to last post
  5. Can't Stabilize IAC

    Started by ScottAB, 02-01-2020 04:35 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 579
    Yesterday, 02:29 PM Go to last post
  6. Tach Causing Misfires

    Started by djh61187, Yesterday 06:17 AM
    • Replies: 5
    • Views: 70
    Yesterday, 01:23 PM Go to last post
  7. Carb spacer on Sniper systems?

    Started by Jasonh136, 02-22-2020 04:19 PM
    • Replies: 9
    • Views: 158
    Yesterday, 01:03 PM Go to last post
  8. 12-920 pump big enough for Sniper 2×4?

    Started by ArtVandelay, 02-22-2020 04:51 PM
    • Replies: 5
    • Views: 90
    Yesterday, 12:34 AM Go to last post
  9. Test Download

    Started by Sosautomotive, 02-17-2020 11:33 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 288
    02-21-2020, 10:07 PM Go to last post
  10. Sniper maxes out Learn Table in one area of the table.

    Started by cruizin01, 03-09-2019 03:07 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,059
    02-21-2020, 03:06 AM Go to last post
  11. Surge Issue

    Started by Rik, 02-19-2020 04:41 PM
    • Replies: 5
    • Views: 186
    02-20-2020, 11:43 PM Go to last post
  12. Stalls when throttle applied in drive - idles good though.

    Started by 1969customS, 02-15-2020 08:30 PM
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 638
    02-20-2020, 11:26 PM Go to last post
  13. Sniper QuadraJet Idle Issues

    Started by HoTuned, 02-17-2020 11:52 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 254
    02-20-2020, 11:22 PM Go to last post
  14. Sniper Blowing Fuses

    Started by Harveyd9, 06-11-2018 04:23 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 1,764
    02-20-2020, 11:50 AM Go to last post
  15. Sniper EFI VS Sniper QuadraJet

    Started by AnthonyF, 02-19-2020 05:53 PM
    • Replies: 1
    • Views: 65
    02-19-2020, 06:24 PM Go to last post
    • Replies: 6
    • Views: 209
    02-19-2020, 02:36 PM Go to last post
  16. Question Effect of New Exhaust System

    Started by tom8034, 02-18-2020 11:06 AM
    • Replies: 4
    • Views: 165
    02-19-2020, 12:38 AM Go to last post
    • Replies: 2
    • Views: 120
    02-18-2020, 10:42 AM Go to last post
  17. Missing data points with engine not running.

    Started by limpsilver, 01-28-2020 11:04 AM
    2 Pages
    1 2
    • Replies: 18
    • Views: 674
    02-18-2020, 09:22 AM Go to last post
  18. Dead ECU?

    Started by NAVY7797, 01-09-2020 08:05 PM
    3 Pages
    1 2 3
    • Replies: 26
    • Views: 1,073
    02-17-2020, 11:08 AM Go to last post
  19. Fuel pump pickup location.

    Started by RealWing, 02-16-2020 04:12 PM
    • Replies: 3
    • Views: 95
    02-17-2020, 12:01 AM Go to last post
  20. Initial fire-up help.

    Started by Mercury 100, 02-07-2020 01:42 PM
    • Replies: 6
    • Views: 317
    02-16-2020, 10:12 PM Go to last post
  21. Need Help With New Install Startup - Datalog & Config Attached

    Started by norm209326, 01-07-2020 08:16 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 722
    02-16-2020, 10:02 PM Go to last post
  22. IAC goes high, when is Learning done?

    Started by TriplaneDave, 02-15-2020 11:03 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 279
    02-15-2020, 09:59 PM Go to last post
  23. Another thread about hooking up the TACH to the Sniper.

    Started by 1969customS, 02-06-2020 01:16 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 37
    • Views: 1,212
    02-15-2020, 09:10 PM Go to last post

Page 1 of 88 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us