Page 1 of 91 1231151 ... LastLast
Threads 1 to 25 of 2262

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 13,017
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 24,162
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 9,513
    07-21-2017, 04:16 PM Go to last post
  1. Popping at high RPM.

    Started by Ososexychevelle, Today 01:50 PM
    • Replies: 6
    • Views: 99
    Today, 07:15 PM Go to last post
  2. 350/700R4 Downshift Stall & Tuning

    Started by PiratesC20, Today 03:07 PM
    • Replies: 2
    • Views: 35
    Today, 06:59 PM Go to last post
  3. New Sniper install, runs perfect until it just stops.

    Started by stacked33, Yesterday 03:49 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 302
    Today, 06:03 PM Go to last post
  4. Ignition Reference Angle

    Started by richie49, Today 05:43 PM
    • Replies: 1
    • Views: 26
    Today, 05:58 PM Go to last post
  5. Sniper XFlow Questions

    Started by Not_Available, 03-30-2020 09:24 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 53
    • Views: 878
    Today, 02:47 PM Go to last post
  6. Newbie that would like to learn.

    Started by mdille, Yesterday 05:23 PM
    • Replies: 7
    • Views: 118
    Today, 01:06 PM Go to last post
  7. Refresh Sniper

    Started by mixman98, Yesterday 04:34 AM
    • Replies: 6
    • Views: 86
    Yesterday, 06:15 AM Go to last post
  8. Issue going into WOT.

    Started by z2812b, 03-31-2020 09:55 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 267
    04-02-2020, 11:04 PM Go to last post
  9. Going lean after start.

    Started by 78 C10, 03-21-2020 09:11 PM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 553
    04-02-2020, 05:07 PM Go to last post
  10. Sniper clicks when starting.

    Started by JohnnyK, 04-02-2020 04:36 PM
    • Replies: 1
    • Views: 62
    04-02-2020, 04:52 PM Go to last post
  11. New Exhaust & Adjustment?

    Started by jc03, 01-27-2020 03:48 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 634
    04-02-2020, 04:38 PM Go to last post
  12. SBC Single-Plane Learn Table

    Started by thecowwatcher, 03-31-2020 09:19 PM
    • Replies: 5
    • Views: 128
    04-01-2020, 05:09 PM Go to last post
  13. Let’s talk about sticking secondaries.

    Started by BMWM.D., 03-30-2020 08:02 PM
    • Replies: 5
    • Views: 155
    03-31-2020, 12:46 AM Go to last post
    • Replies: 3
    • Views: 126
    03-30-2020, 02:51 PM Go to last post
  14. Timing control at low RPM cruise?

    Started by stinkfinger, 04-22-2019 04:00 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 1,752
    03-30-2020, 01:08 PM Go to last post
  15. Sniper Stealth & CD Ignition

    Started by Firebirdjones, 03-29-2020 10:06 PM
    • Replies: 9
    • Views: 145
    03-30-2020, 01:06 PM Go to last post
  16. Sniper Stealth IAC Motor

    Started by BMWM.D., 03-22-2020 03:19 PM
    • Replies: 4
    • Views: 130
    03-29-2020, 10:27 PM Go to last post
  17. Marine 454 IAC setting unknown variables.

    Started by Don Petrey, 03-17-2020 02:06 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 685
    03-29-2020, 01:58 AM Go to last post
    • Replies: 8
    • Views: 261
    03-28-2020, 11:05 PM Go to last post
  18. Fuel Supply

    Started by Stroked1966stang, 12-16-2019 01:33 PM
    • Replies: 7
    • Views: 510
    03-27-2020, 06:01 PM Go to last post
  19. Sniper Timing Control

    Started by Marks67caro, 03-27-2020 02:26 PM
    • Replies: 5
    • Views: 182
    03-27-2020, 04:53 PM Go to last post
  20. AFR goes wacko during cruise.

    Started by Johnret, 03-26-2020 06:27 PM
    • Replies: 5
    • Views: 161
    03-27-2020, 11:12 AM Go to last post
  21. Too much fuel on initial pump prime.

    Started by Jeff Parker, 03-24-2020 09:25 PM
    • Replies: 9
    • Views: 297
    03-26-2020, 07:30 AM Go to last post
  22. Is a generator system OK with Sniper EFI?

    Started by otterby, 03-25-2020 11:16 AM
    • Replies: 2
    • Views: 116
    03-25-2020, 02:06 PM Go to last post
  23. Fuel Pressure

    Started by bingo2, 03-25-2020 10:23 AM
    • Replies: 3
    • Views: 121
    03-25-2020, 10:55 AM Go to last post

Page 1 of 91 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us