Page 1 of 80 1231151 ... LastLast
Threads 1 to 25 of 1994

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 9,517
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 18,989
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 6,266
    07-21-2017, 04:16 PM Go to last post
    • Replies: 2
    • Views: 12
    Today, 01:09 PM Go to last post
  1. Sniper Won't Learn

    Started by HeavyChevy, Yesterday 09:37 PM
    • Replies: 6
    • Views: 79
    Today, 11:59 AM Go to last post
  2. Throttle Sticking

    Started by mixman98, 10-12-2019 07:36 AM
    • Replies: 7
    • Views: 249
    Today, 11:07 AM Go to last post
  3. Losing tach signal when engine gets up to temp?

    Started by streetking408ys, 10-12-2019 01:36 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 342
    Today, 10:06 AM Go to last post
  4. Where do I wire Output #2 to control fans?

    Started by cnaegler, Yesterday 04:21 PM
    • Replies: 7
    • Views: 66
    Yesterday, 10:57 PM Go to last post
  5. MAT reading way off.

    Started by kellysedars, 10-19-2019 09:03 PM
    • Replies: 1
    • Views: 84
    Yesterday, 05:21 AM Go to last post
  6. SD card won't communicate with handheld.

    Started by Gandyman64, 10-19-2019 03:47 PM
    • Replies: 2
    • Views: 75
    10-19-2019, 08:24 PM Go to last post
  7. Config File

    Started by original68, 10-19-2019 05:21 PM
    • Replies: 2
    • Views: 85
    10-19-2019, 06:18 PM Go to last post
  8. Question Regulator Cover & Rubber Bumper?

    Started by Steamer, 10-19-2019 01:23 PM
    • Replies: 0
    • Views: 158
    10-19-2019, 01:23 PM Go to last post
  9. Ran great for an hour, now at No ECU. PLEASE HELP

    Started by tdford5, 07-16-2019 02:07 AM
    • Replies: 6
    • Views: 388
    10-19-2019, 11:14 AM Go to last post
  10. Anybody running a Blueprint Pro Series SBC 427?

    Started by Crash, 10-06-2019 01:58 AM
    • Replies: 2
    • Views: 221
    10-19-2019, 10:23 AM Go to last post
  11. This idle...killing me.

    Started by Montzilla, 07-20-2019 05:36 PM
    • Replies: 7
    • Views: 619
    10-19-2019, 12:42 AM Go to last post
  12. Pinched yellow wire from coil −.

    Started by Chris805, 07-26-2019 09:10 PM
    • Replies: 8
    • Views: 576
    10-19-2019, 12:39 AM Go to last post
  13. IAC got stuck again.

    Started by HeavyChevy, 09-10-2019 10:29 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 39
    • Views: 1,141
    10-19-2019, 12:24 AM Go to last post
  14. Mid-Range Misfire Problem

    Started by ddl67, 10-16-2019 03:25 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 459
    10-18-2019, 04:13 PM Go to last post
  15. Did I make a mistake?

    Started by Jodirte, 10-12-2019 05:45 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 592
    10-16-2019, 06:22 PM Go to last post
  16. Using charcoal canister & vent?

    Started by Rumblefish, 10-14-2019 03:01 PM
    • Replies: 3
    • Views: 182
    10-15-2019, 12:57 PM Go to last post
    • Replies: 3
    • Views: 165
    10-14-2019, 08:08 AM Go to last post
  17. Help needed configuring used Sniper unit.

    Started by danford1, 09-30-2019 05:37 PM
    • Replies: 5
    • Views: 331
    10-12-2019, 09:35 PM Go to last post
  18. Datalog vs Configuration File

    Started by original68, 10-12-2019 12:28 PM
    • Replies: 6
    • Views: 162
    10-12-2019, 05:27 PM Go to last post
  19. WBO2 Sensor?

    Started by Elwaupo, 10-07-2019 06:02 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 315
    10-11-2019, 07:33 PM Go to last post
  20. Sniper with Digital Dash & odometer?

    Started by Journeywork, 10-10-2019 05:30 PM
    • Replies: 7
    • Views: 212
    10-11-2019, 04:47 PM Go to last post
  21. Holley Sniper cutting out, losing power.

    Started by thunderbyte, 07-27-2018 08:06 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 3,768
    10-11-2019, 08:55 AM Go to last post
  22. Leaking fuel from under right hand bowl.

    Started by 67Charger, 10-11-2019 06:53 AM
    • Replies: 0
    • Views: 259
    10-11-2019, 06:53 AM Go to last post

Page 1 of 80 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us