Page 1 of 80 1231151 ... LastLast
Threads 1 to 25 of 1990

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 9,476
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 18,935
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 6,227
    07-21-2017, 04:16 PM Go to last post
  1. MAT reading way off

    Started by kellysedars, Yesterday 09:03 PM
    • Replies: 0
    • Views: 16
    Yesterday, 09:03 PM Go to last post
  2. SD card won't communicate with handheld.

    Started by Gandyman64, Yesterday 03:47 PM
    • Replies: 2
    • Views: 37
    Yesterday, 08:24 PM Go to last post
    • Replies: 5
    • Views: 159
    Yesterday, 06:26 PM Go to last post
  3. Config File

    Started by original68, Yesterday 05:21 PM
    • Replies: 2
    • Views: 30
    Yesterday, 06:18 PM Go to last post
  4. Question Regulator Cover & Rubber Bumper?

    Started by Steamer, Yesterday 01:23 PM
    • Replies: 0
    • Views: 135
    Yesterday, 01:23 PM Go to last post
  5. Ran great for an hour, now at No ECU. PLEASE HELP

    Started by tdford5, 07-16-2019 02:07 AM
    • Replies: 6
    • Views: 359
    Yesterday, 11:14 AM Go to last post
  6. Anybody running a Blueprint Pro Series SBC 427?

    Started by Crash, 10-06-2019 01:58 AM
    • Replies: 2
    • Views: 154
    Yesterday, 10:23 AM Go to last post
  7. This idle...killing me.

    Started by Montzilla, 07-20-2019 05:36 PM
    • Replies: 7
    • Views: 570
    Yesterday, 12:42 AM Go to last post
  8. Pinched yellow wire from coil −.

    Started by Chris805, 07-26-2019 09:10 PM
    • Replies: 8
    • Views: 521
    Yesterday, 12:39 AM Go to last post
  9. IAC got stuck again.

    Started by HeavyChevy, 09-10-2019 10:29 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 39
    • Views: 1,052
    Yesterday, 12:24 AM Go to last post
  10. Mid-Range Misfire Problem

    Started by ddl67, 10-16-2019 03:25 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 403
    10-18-2019, 04:13 PM Go to last post
  11. Throttle Sticking

    Started by mixman98, 10-12-2019 07:36 AM
    • Replies: 6
    • Views: 217
    10-17-2019, 05:56 PM Go to last post
  12. Did I make a mistake?

    Started by Jodirte, 10-12-2019 05:45 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 540
    10-16-2019, 06:22 PM Go to last post
  13. Using charcoal canister & vent?

    Started by Rumblefish, 10-14-2019 03:01 PM
    • Replies: 3
    • Views: 161
    10-15-2019, 12:57 PM Go to last post
    • Replies: 3
    • Views: 150
    10-14-2019, 08:08 AM Go to last post
  14. Help needed configuring used Sniper unit.

    Started by danford1, 09-30-2019 05:37 PM
    • Replies: 5
    • Views: 313
    10-12-2019, 09:35 PM Go to last post
  15. Datalog vs Configuration File

    Started by original68, 10-12-2019 12:28 PM
    • Replies: 6
    • Views: 135
    10-12-2019, 05:27 PM Go to last post
  16. WBO2 Sensor?

    Started by Elwaupo, 10-07-2019 06:02 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 279
    10-11-2019, 07:33 PM Go to last post
  17. Sniper with Digital Dash & odometer?

    Started by Journeywork, 10-10-2019 05:30 PM
    • Replies: 7
    • Views: 192
    10-11-2019, 04:47 PM Go to last post
  18. Holley Sniper cutting out, losing power.

    Started by thunderbyte, 07-27-2018 08:06 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 3,709
    10-11-2019, 08:55 AM Go to last post
  19. Leaking fuel from under right hand bowl.

    Started by 67Charger, 10-11-2019 06:53 AM
    • Replies: 0
    • Views: 177
    10-11-2019, 06:53 AM Go to last post
  20. First Datalog Sniper Timing

    Started by 84capri, 10-07-2019 10:06 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 309
    10-10-2019, 10:12 PM Go to last post
    • Replies: 25
    • Views: 776
    10-10-2019, 01:11 PM Go to last post
  21. Camaro runs terrible until warmed up.

    Started by YumaCamaro, 10-08-2019 03:37 PM
    • Replies: 4
    • Views: 182
    10-10-2019, 01:01 PM Go to last post
  22. Truck running poorly.

    Started by Gandyman64, 10-08-2019 06:53 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 353
    10-10-2019, 02:37 AM Go to last post

Page 1 of 80 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us