Page 1 of 122 1231151101 ... LastLast
Threads 1 to 25 of 3036

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 22,525
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 37,755
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 18,432
    07-21-2017, 04:16 PM Go to last post
  1. ECU resets/EMI issues after HyperSpark install.

    Started by BMWM.D., 01-19-2021 10:43 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 353
    Today, 11:22 AM Go to last post
  2. Do I need a better air filter?

    Started by mehoff636, 01-23-2021 08:51 PM
    • Replies: 8
    • Views: 165
    Today, 10:31 AM Go to last post
  3. Intake Spacer yes or no?

    Started by Isahia, 01-23-2021 11:22 PM
    • Replies: 5
    • Views: 141
    Today, 10:27 AM Go to last post
  4. Broken starter from kickback on cold start.

    Started by ctgoll, Yesterday 02:38 PM
    • Replies: 6
    • Views: 136
    Today, 09:25 AM Go to last post
  5. Holley Sniper Control Timing on LSx

    Started by Rdf1, Today 09:23 AM
    • Replies: 0
    • Views: 9
    Today, 09:23 AM Go to last post
  6. 383 SBC Tuning Help

    Started by Gordon_383, Today 12:43 AM
    • Replies: 3
    • Views: 67
    Today, 07:13 AM Go to last post
  7. No tach signal, there was once.

    Started by Bluelionpiper, Yesterday 03:53 PM
    • Replies: 2
    • Views: 78
    Yesterday, 10:13 PM Go to last post
  8. New Sniper, few questions.

    Started by pallidaomen, 01-22-2021 07:15 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 342
    Yesterday, 10:02 PM Go to last post
  9. Possible EMI issue?

    Started by jdeignan, Yesterday 05:24 PM
    • Replies: 1
    • Views: 65
    Yesterday, 07:13 PM Go to last post
    • Replies: 5
    • Views: 135
    Yesterday, 04:15 PM Go to last post
  10. I HATE Rats

    Started by Not_Available, 01-15-2021 01:40 PM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 958
    Yesterday, 10:24 AM Go to last post
    • Replies: 2
    • Views: 105
    Yesterday, 01:57 AM Go to last post
  11. Older 6AL box with HyperSpark?

    Started by BMWM.D., 01-23-2021 10:23 AM
    • Replies: 3
    • Views: 94
    Yesterday, 12:21 AM Go to last post
  12. 562-1 Fuel Filter Mount

    Started by midias, 01-21-2021 01:45 PM
    • Replies: 6
    • Views: 206
    01-23-2021, 07:17 PM Go to last post
  13. Need advice on small issues.

    Started by Rtchaney, 01-22-2021 06:33 AM
    • Replies: 6
    • Views: 194
    01-23-2021, 07:14 PM Go to last post
  14. Intermittent high idle - Sniper EFI.

    Started by Harveyd9, 03-31-2018 12:54 PM
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 13,820
    01-23-2021, 12:09 PM Go to last post
  15. AFR "HEATING" or "UNPLUGGED", stalls out.

    Started by MCS, 01-08-2021 11:47 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 478
    01-23-2021, 02:51 AM Go to last post
  16. Injector Noise

    Started by jack15t, 01-11-2021 09:24 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 450
    01-22-2021, 08:51 PM Go to last post
  17. Sniper with Dakota Digital Dash?

    Started by AndyF, 01-22-2021 01:09 PM
    • Replies: 1
    • Views: 80
    01-22-2021, 07:30 PM Go to last post
  18. 565-322 With Dual-Plane Intake

    Started by Scott Evans, 01-18-2021 05:42 PM
    • Replies: 8
    • Views: 377
    01-22-2021, 09:22 AM Go to last post
  19. Computer controlled timing with OE ignition.

    Started by Rusty_S85, 01-20-2021 09:43 PM
    • Replies: 3
    • Views: 141
    01-21-2021, 10:32 PM Go to last post
  20. Newby, I can't get my Sniper EFI to cold idle correctly.

    Started by Cliffdude, 01-18-2021 07:35 PM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 621
    01-21-2021, 12:18 AM Go to last post
  21. Sniper 2300 spraying fuel out TBI barrels.

    Started by Wbshelton, 01-15-2020 10:36 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 867
    01-20-2021, 08:58 PM Go to last post
  22. Bosch 009 Distributor timing control?

    Started by V6opel, 12-17-2019 06:33 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 2,244
    01-20-2021, 03:38 PM Go to last post
  23. New engine being built.

    Started by randavis, 01-19-2021 06:21 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 285
    01-20-2021, 10:12 AM Go to last post

Page 1 of 122 1231151101 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us