Page 1 of 80 1231151 ... LastLast
Threads 1 to 25 of 1997

Forum: Sniper EFI

Sniper EFI Tuning & Tech

  1. Sticky Thread Sticky: Incompatible Handheld Firmware

    Started by Matt, 09-29-2017 04:55 PM
    • Replies: 0
    • Views: 9,551
    09-29-2017, 04:55 PM Go to last post
  2. Sticky Thread Sticky: Useful Sniper EFI Information

    Started by Matt, 07-21-2017 11:16 AM
    • Replies: 1
    • Views: 19,043
    07-24-2017, 08:52 AM Go to last post
  3. Sticky Thread Sticky: Sniper EFI Replacement Part Numbers

    Started by Matt, 07-21-2017 04:16 PM
    • Replies: 0
    • Views: 6,292
    07-21-2017, 04:16 PM Go to last post
    • Replies: 2
    • Views: 3
    Today, 01:28 AM Go to last post
    • Replies: 9
    • Views: 306
    Yesterday, 09:40 PM Go to last post
    • Replies: 0
    • Views: 25
    Yesterday, 08:37 PM Go to last post
  1. Totally new to EFI.

    Started by Dcjeepster, 10-21-2019 09:11 PM
    • Replies: 3
    • Views: 96
    Yesterday, 06:04 PM Go to last post
  2. Sniper Won't Learn

    Started by HeavyChevy, 10-20-2019 09:37 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 177
    Yesterday, 06:01 PM Go to last post
  3. Holley Sniper HyperSpark phasing issues.

    Started by dccorvettes, 10-07-2019 03:11 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 416
    Yesterday, 12:00 PM Go to last post
  4. Lean spike/shutoff - coasting/engine braking.

    Started by 8pack, 10-21-2019 09:49 AM
    • Replies: 6
    • Views: 92
    Yesterday, 11:45 AM Go to last post
  5. Throttle Sticking

    Started by mixman98, 10-12-2019 07:36 AM
    • Replies: 9
    • Views: 318
    Yesterday, 12:09 AM Go to last post
    • Replies: 3
    • Views: 80
    10-21-2019, 11:47 PM Go to last post
  6. Unknown Issue/Bogging Out

    Started by SAB, 09-30-2019 10:52 AM
    • Replies: 7
    • Views: 348
    10-21-2019, 04:37 PM Go to last post
  7. Losing tach signal when engine gets up to temp?

    Started by streetking408ys, 10-12-2019 01:36 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 420
    10-21-2019, 02:53 PM Go to last post
  8. Where do I wire Output #2 to control fans?

    Started by cnaegler, 10-20-2019 04:21 PM
    • Replies: 7
    • Views: 97
    10-20-2019, 10:57 PM Go to last post
  9. MAT reading way off.

    Started by kellysedars, 10-19-2019 09:03 PM
    • Replies: 1
    • Views: 99
    10-20-2019, 05:21 AM Go to last post
  10. SD card won't communicate with handheld.

    Started by Gandyman64, 10-19-2019 03:47 PM
    • Replies: 2
    • Views: 85
    10-19-2019, 08:24 PM Go to last post
  11. Config File

    Started by original68, 10-19-2019 05:21 PM
    • Replies: 2
    • Views: 93
    10-19-2019, 06:18 PM Go to last post
  12. Question Regulator Cover & Rubber Bumper?

    Started by Steamer, 10-19-2019 01:23 PM
    • Replies: 0
    • Views: 168
    10-19-2019, 01:23 PM Go to last post
  13. Ran great for an hour, now at No ECU. PLEASE HELP

    Started by tdford5, 07-16-2019 02:07 AM
    • Replies: 6
    • Views: 397
    10-19-2019, 11:14 AM Go to last post
  14. Anybody running a Blueprint Pro Series SBC 427?

    Started by Crash, 10-06-2019 01:58 AM
    • Replies: 2
    • Views: 252
    10-19-2019, 10:23 AM Go to last post
  15. This idle...killing me.

    Started by Montzilla, 07-20-2019 05:36 PM
    • Replies: 7
    • Views: 634
    10-19-2019, 12:42 AM Go to last post
  16. Pinched yellow wire from coil −.

    Started by Chris805, 07-26-2019 09:10 PM
    • Replies: 8
    • Views: 603
    10-19-2019, 12:39 AM Go to last post
  17. IAC got stuck again.

    Started by HeavyChevy, 09-10-2019 10:29 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 39
    • Views: 1,163
    10-19-2019, 12:24 AM Go to last post
  18. Mid-Range Misfire Problem

    Started by ddl67, 10-16-2019 03:25 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 482
    10-18-2019, 04:13 PM Go to last post
  19. Did I make a mistake?

    Started by Jodirte, 10-12-2019 05:45 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 614
    10-16-2019, 06:22 PM Go to last post
  20. Using charcoal canister & vent?

    Started by Rumblefish, 10-14-2019 03:01 PM
    • Replies: 3
    • Views: 193
    10-15-2019, 12:57 PM Go to last post
    • Replies: 3
    • Views: 172
    10-14-2019, 08:08 AM Go to last post

Page 1 of 80 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us