Page 1 of 84 1231151 ... LastLast
Threads 1 to 25 of 2081

Forum: HP EFI

HP EFI Tuning & Tech

  1. Sticky Thread Sticky: HP Potential RPM Input Problem

    Started by Doug F, 10-12-2010 04:57 PM
    • Replies: 0
    • Views: 12,738
    10-12-2010, 04:57 PM Go to last post
    • Replies: 0
    • Views: 13,394
    07-12-2010, 04:14 PM Go to last post
  1. Dual Sync Setup Question

    Started by weendoggy, 12-14-2018 07:33 PM
    • Replies: 1
    • Views: 41
    Yesterday, 09:28 AM Go to last post
  2. Injector Flow & Injector Off Time Data

    Started by 35nomoon, 12-14-2018 12:21 PM
    • Replies: 3
    • Views: 58
    Yesterday, 12:48 AM Go to last post
  3. Holley HP Install - Need advice on routing wires, etc.

    Started by TurboCow, 12-01-2018 02:08 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 50
    • Views: 775
    12-14-2018, 10:35 AM Go to last post
  4. Fox Mustang Installation

    Started by caryd, 12-12-2018 10:30 AM
    • Replies: 5
    • Views: 55
    12-12-2018, 02:23 PM Go to last post
  5. Driveshaft Sensor Installation

    Started by procharged67, 03-05-2017 03:05 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,391
    12-12-2018, 11:38 AM Go to last post
  6. Lightbulb Retard Timing after acceleration/during overrun.

    Started by paddyrk, 11-29-2018 09:39 PM
    antilag, crackles, overrun, pops, retard timing
    • Replies: 6
    • Views: 140
    12-11-2018, 12:45 AM Go to last post
  7. Injector Harness & Ford Firing Order

    Started by dalcini, 12-07-2018 02:59 PM
    550-200, 550-213, 550-604, harness, injectors
    • Replies: 6
    • Views: 92
    12-10-2018, 01:06 AM Go to last post
  8. HP build 110 not showing second AFR.

    Started by jdefina, 12-08-2018 04:03 PM
    • Replies: 2
    • Views: 82
    12-09-2018, 11:32 AM Go to last post
  9. Injector Voltage

    Started by Gbgn1, 12-04-2018 10:14 PM
    • Replies: 1
    • Views: 54
    12-05-2018, 12:51 AM Go to last post
  10. Stumble at 4K RPM under acceleration.

    Started by riche, 06-22-2018 07:20 AM
    • Replies: 9
    • Views: 348
    12-04-2018, 12:06 PM Go to last post
  11. Closed Loop

    Started by TMFK, 12-02-2018 08:54 PM
    • Replies: 1
    • Views: 99
    12-03-2018, 12:56 AM Go to last post
  12. Rev Limiter, Transbrake, I/O

    Started by oldskool, 11-29-2018 11:28 PM
    • Replies: 5
    • Views: 91
    11-30-2018, 01:40 PM Go to last post
  13. Poor man's traction control?

    Started by racindego, 05-05-2016 11:22 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 4,628
    11-29-2018, 08:47 PM Go to last post
  14. MAP kPa vs PSIG not matching.

    Started by Jay@HAP, 11-27-2018 12:31 PM
    • Replies: 3
    • Views: 118
    11-27-2018, 01:54 PM Go to last post
  15. Cam Sensor

    Started by G3mustang, 06-21-2017 10:44 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,299
    11-26-2018, 12:07 AM Go to last post
  16. Fuel Pressure Safety

    Started by George F, 11-19-2018 04:30 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 375
    11-22-2018, 02:52 PM Go to last post
  17. Which base calibration?

    Started by 35nomoon, 11-22-2018 01:14 PM
    • Replies: 1
    • Views: 113
    11-22-2018, 02:01 PM Go to last post
  18. Hall-Effect cam/crank distributor setup.

    Started by Imlach90, 10-27-2018 11:54 PM
    • Replies: 4
    • Views: 234
    11-21-2018, 10:56 PM Go to last post
  19. Math Channel as an input?

    Started by Badassbird, 11-20-2018 09:30 AM
    • Replies: 1
    • Views: 75
    11-20-2018, 09:54 AM Go to last post
  20. Magnetic Pickup vs Dual Sync Distributors

    Started by Sewngo, 11-18-2018 08:47 PM
    • Replies: 2
    • Views: 140
    11-19-2018, 12:21 AM Go to last post
    • Replies: 4
    • Views: 220
    11-17-2018, 11:15 AM Go to last post
  21. Lull in throttle response.

    Started by SEINSMELD, 11-12-2018 10:44 PM
    • Replies: 1
    • Views: 133
    11-13-2018, 03:21 AM Go to last post
  22. Let me help you with Injector End Angle.

    Started by allan5oh, 07-06-2018 11:32 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 69
    • Views: 4,581
    11-12-2018, 11:30 PM Go to last post
  23. Injector data for Bosch High Z injectors.

    Started by allan5oh, 11-09-2018 01:46 PM
    • Replies: 2
    • Views: 119
    11-10-2018, 01:05 AM Go to last post
  24. Angry IAC Letting Air in Always

    Started by paddyrk, 11-09-2018 05:43 PM
    • Replies: 1
    • Views: 143
    11-09-2018, 05:49 PM Go to last post

Page 1 of 84 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us