Page 1 of 84 1231151 ... LastLast
Threads 1 to 25 of 2080

Forum: HP EFI

HP EFI Tuning & Tech

  1. Sticky Thread Sticky: HP Potential RPM Input Problem

    Started by Doug F, 10-12-2010 04:57 PM
    • Replies: 0
    • Views: 12,729
    10-12-2010, 04:57 PM Go to last post
    • Replies: 0
    • Views: 13,384
    07-12-2010, 04:14 PM Go to last post
  1. Injector Flow & Injector Off Time Data

    Started by 35nomoon, Today 12:21 PM
    • Replies: 1
    • Views: 14
    Today, 12:42 PM Go to last post
  2. Holley HP Install - Need advice on routing wires, etc.

    Started by TurboCow, 12-01-2018 02:08 PM
    6 Pages
    1 2 3 ... 6
    • Replies: 50
    • Views: 736
    Today, 10:35 AM Go to last post
  3. Fox Mustang Installation

    Started by caryd, 12-12-2018 10:30 AM
    • Replies: 5
    • Views: 47
    12-12-2018, 02:23 PM Go to last post
  4. Driveshaft Sensor Installation

    Started by procharged67, 03-05-2017 03:05 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,377
    12-12-2018, 11:38 AM Go to last post
  5. Lightbulb Retard Timing after acceleration/during overrun.

    Started by paddyrk, 11-29-2018 09:39 PM
    antilag, crackles, overrun, pops, retard timing
    • Replies: 6
    • Views: 139
    12-11-2018, 12:45 AM Go to last post
  6. Injector Harness & Ford Firing Order

    Started by dalcini, 12-07-2018 02:59 PM
    550-200, 550-213, 550-604, harness, injectors
    • Replies: 6
    • Views: 92
    12-10-2018, 01:06 AM Go to last post
  7. HP build 110 not showing second AFR.

    Started by jdefina, 12-08-2018 04:03 PM
    • Replies: 2
    • Views: 81
    12-09-2018, 11:32 AM Go to last post
  8. Injector Voltage

    Started by Gbgn1, 12-04-2018 10:14 PM
    • Replies: 1
    • Views: 54
    12-05-2018, 12:51 AM Go to last post
  9. Stumble at 4K RPM under acceleration.

    Started by riche, 06-22-2018 07:20 AM
    • Replies: 9
    • Views: 347
    12-04-2018, 12:06 PM Go to last post
  10. Closed Loop

    Started by TMFK, 12-02-2018 08:54 PM
    • Replies: 1
    • Views: 98
    12-03-2018, 12:56 AM Go to last post
  11. Rev Limiter, Transbrake, I/O

    Started by oldskool, 11-29-2018 11:28 PM
    • Replies: 5
    • Views: 90
    11-30-2018, 01:40 PM Go to last post
  12. Poor man's traction control?

    Started by racindego, 05-05-2016 11:22 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 4,609
    11-29-2018, 08:47 PM Go to last post
  13. MAP kPa vs PSIG not matching.

    Started by Jay@HAP, 11-27-2018 12:31 PM
    • Replies: 3
    • Views: 115
    11-27-2018, 01:54 PM Go to last post
  14. Cam Sensor

    Started by G3mustang, 06-21-2017 10:44 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,295
    11-26-2018, 12:07 AM Go to last post
  15. Fuel Pressure Safety

    Started by George F, 11-19-2018 04:30 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 374
    11-22-2018, 02:52 PM Go to last post
  16. Which base calibration?

    Started by 35nomoon, 11-22-2018 01:14 PM
    • Replies: 1
    • Views: 111
    11-22-2018, 02:01 PM Go to last post
  17. Hall-Effect cam/crank distributor setup.

    Started by Imlach90, 10-27-2018 11:54 PM
    • Replies: 4
    • Views: 233
    11-21-2018, 10:56 PM Go to last post
  18. Math Channel as an input?

    Started by Badassbird, 11-20-2018 09:30 AM
    • Replies: 1
    • Views: 73
    11-20-2018, 09:54 AM Go to last post
  19. Magnetic Pickup vs Dual Sync Distributors

    Started by Sewngo, 11-18-2018 08:47 PM
    • Replies: 2
    • Views: 137
    11-19-2018, 12:21 AM Go to last post
    • Replies: 4
    • Views: 219
    11-17-2018, 11:15 AM Go to last post
  20. Lull in throttle response.

    Started by SEINSMELD, 11-12-2018 10:44 PM
    • Replies: 1
    • Views: 132
    11-13-2018, 03:21 AM Go to last post
  21. Let me help you with Injector End Angle.

    Started by allan5oh, 07-06-2018 11:32 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 69
    • Views: 4,571
    11-12-2018, 11:30 PM Go to last post
  22. Injector data for Bosch High Z injectors.

    Started by allan5oh, 11-09-2018 01:46 PM
    • Replies: 2
    • Views: 118
    11-10-2018, 01:05 AM Go to last post
  23. Angry IAC Letting Air in Always

    Started by paddyrk, 11-09-2018 05:43 PM
    • Replies: 1
    • Views: 142
    11-09-2018, 05:49 PM Go to last post
  24. New HP EFI engine, not starting, no spark.

    Started by Sutphen, 11-08-2018 03:47 PM
    • Replies: 4
    • Views: 163
    11-08-2018, 04:57 PM Go to last post

Page 1 of 84 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us