Page 1 of 84 1231151 ... LastLast
Threads 1 to 25 of 2078

Forum: HP EFI

HP EFI Tuning & Tech

  1. Sticky Thread Sticky: HP Potential RPM Input Problem

    Started by Doug F, 10-12-2010 04:57 PM
    • Replies: 0
    • Views: 12,711
    10-12-2010, 04:57 PM Go to last post
    • Replies: 0
    • Views: 13,356
    07-12-2010, 04:14 PM Go to last post
  1. Lightbulb Retard Timing after acceleration/during overrun.

    Started by paddyrk, 11-29-2018 09:39 PM
    antilag, crackles, overrun, pops, retard timing
    • Replies: 6
    • Views: 107
    Today, 12:45 AM Go to last post
  2. Injector Harness & Ford Firing Order

    Started by dalcini, 12-07-2018 02:59 PM
    550-200, 550-213, 550-604, harness, injectors
    • Replies: 6
    • Views: 73
    Yesterday, 01:06 AM Go to last post
  3. HP build 110 not showing second AFR.

    Started by jdefina, 12-08-2018 04:03 PM
    • Replies: 2
    • Views: 67
    12-09-2018, 11:32 AM Go to last post
  4. Driveshaft Sensor Installation

    Started by procharged67, 03-05-2017 03:05 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,296
    12-06-2018, 03:35 PM Go to last post
  5. Holley HP Install - Need advice on routing wires, etc.

    Started by TurboCow, 12-01-2018 02:08 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 43
    • Views: 573
    12-05-2018, 02:54 AM Go to last post
  6. Injector Voltage

    Started by Gbgn1, 12-04-2018 10:14 PM
    • Replies: 1
    • Views: 49
    12-05-2018, 12:51 AM Go to last post
  7. Stumble at 4K RPM under acceleration.

    Started by riche, 06-22-2018 07:20 AM
    • Replies: 9
    • Views: 341
    12-04-2018, 12:06 PM Go to last post
  8. Closed Loop

    Started by TMFK, 12-02-2018 08:54 PM
    • Replies: 1
    • Views: 96
    12-03-2018, 12:56 AM Go to last post
  9. Rev Limiter, Transbrake, I/O

    Started by oldskool, 11-29-2018 11:28 PM
    • Replies: 5
    • Views: 84
    11-30-2018, 01:40 PM Go to last post
  10. Poor man's traction control?

    Started by racindego, 05-05-2016 11:22 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 4,578
    11-29-2018, 08:47 PM Go to last post
  11. MAP kPa vs PSIG not matching.

    Started by Jay@HAP, 11-27-2018 12:31 PM
    • Replies: 3
    • Views: 113
    11-27-2018, 01:54 PM Go to last post
  12. Cam Sensor

    Started by G3mustang, 06-21-2017 10:44 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,287
    11-26-2018, 12:07 AM Go to last post
  13. Fuel Pressure Safety

    Started by George F, 11-19-2018 04:30 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 371
    11-22-2018, 02:52 PM Go to last post
  14. Which base calibration?

    Started by 35nomoon, 11-22-2018 01:14 PM
    • Replies: 1
    • Views: 106
    11-22-2018, 02:01 PM Go to last post
  15. Hall-Effect cam/crank distributor setup.

    Started by Imlach90, 10-27-2018 11:54 PM
    • Replies: 4
    • Views: 229
    11-21-2018, 10:56 PM Go to last post
  16. Math Channel as an input?

    Started by Badassbird, 11-20-2018 09:30 AM
    • Replies: 1
    • Views: 71
    11-20-2018, 09:54 AM Go to last post
  17. Magnetic Pickup vs Dual Sync Distributors

    Started by Sewngo, 11-18-2018 08:47 PM
    • Replies: 2
    • Views: 131
    11-19-2018, 12:21 AM Go to last post
    • Replies: 4
    • Views: 217
    11-17-2018, 11:15 AM Go to last post
  18. Lull in throttle response.

    Started by SEINSMELD, 11-12-2018 10:44 PM
    • Replies: 1
    • Views: 131
    11-13-2018, 03:21 AM Go to last post
  19. Let me help you with Injector End Angle.

    Started by allan5oh, 07-06-2018 11:32 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 69
    • Views: 4,551
    11-12-2018, 11:30 PM Go to last post
  20. Injector data for Bosch High Z injectors.

    Started by allan5oh, 11-09-2018 01:46 PM
    • Replies: 2
    • Views: 116
    11-10-2018, 01:05 AM Go to last post
  21. Angry IAC Letting Air in Always

    Started by paddyrk, 11-09-2018 05:43 PM
    • Replies: 1
    • Views: 136
    11-09-2018, 05:49 PM Go to last post
  22. New HP EFI engine, not starting, no spark.

    Started by Sutphen, 11-08-2018 03:47 PM
    • Replies: 4
    • Views: 159
    11-08-2018, 04:57 PM Go to last post
  23. V5

    Started by George F, 11-06-2018 01:02 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 510
    11-07-2018, 12:36 PM Go to last post
  24. Mounting trigger wheel mounting to harmonic balancer.

    Started by Jeep4.7, 09-06-2018 10:23 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 386
    11-07-2018, 05:18 AM Go to last post

Page 1 of 84 1231151 ... LastLast

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
About us
Holley has been the undisputed leader in fuel systems for over 100 years. Holley carburetors have powered every NASCAR® Sprint® Cup team and nearly every NHRA® Pro–Stock champion for four decades. Now, Holley EFI is dominating the performance world as well as our products for GM's LS engine. Holley's products also include performance fuel pumps, intake manifolds & engine dress–up products for street performance, race and marine applications. As a single solution, or partnered with products from other Holley companies - Hooker Headers, Flowtech Headers, NOS Nitrous, Weiand, Earl's Performance Plumbing, or Diablosport - Holley products can give you the edge you need over the competition.
Join us