Announcement

Collapse
No announcement yet.

Using Holley 554-111 Solenoid Drivers With NOS Progressive Launcher

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Using Holley 554-111 Solenoid Drivers With NOS Progressive Launcher

    Hi all. I have an NOS 8 Fogger Sportsman system with a NOS Progressive Launcher, and also a bottle heater. I've wired everything up, except for the relay trigger cable. I bought two Holley 554-111 high current nitrous solenoid drivers, one for each pair of solenoids. The power is connected to both relays with their output wires connected to the solenoids.

    Now the NOS controller instructions say to connect the earth side of the solenoids to the heavy blue wire on the control module. But because I'm now using the 3 wire relays which have a negative trigger wire, should I connect the relay black/yellow trigger wire to the heavy blue cable of the control module? Then allowing the controller to modulate the solid state relays on & off driving the solenoids, which would then be just grounded to the chassis? If this isn't correct, exactly where should I join the black/yellow trigger to the NOS Launcher? Any help would be really appreciated. Thank you.

  • #2
    http://documents.holley.com/554-111diagram.jpg (Holley 554-111 Solid State Relay Wiring Diagram)
    http://documents.holley.com/199r10466rev1.pdf (NOS 15977NOS Launcher N2O Controller Instructions - For my own reference.)
    May God's grace bless you in the Lord Jesus Christ.
    '92 Ford Mustang GT: 385"/6.3L SBF, Dart SHP 8.2 block, forged steel crankshaft & H-beam rods, forged pistons, Trick Flow Twisted Wedge 11R 205 CNC Comp Ported heads, 12:1 compression ratio, 232-244 duration/.623" lift/114 LSA camshaft, TFS R-Series FTI Comp Ported intake, BBK 80mm throttle body, Holley Dominator MPFI & DIS, Holley 36-1 crank trigger, MSD 1x cam sync, PA PMGR starter, PA 200A 3G alternator, Optima 34/78 Red battery, 100HP progressive dry direct-port NOS, R134a A/C, Spal Dual 12" HP 3168 CFM fans, Frostbite 3-core aluminum radiator, Pypes dual 2.5" exhaust, off-road X-pipe, shorty headers, Earl's -6AN fuel system plumbing, Walbro 255 LPH in-tank pump & Pro-M -6AN hanger, S&W subframe connectors, BMR upper & lower torque box reinforcements, LenTech Strip Terminator wide-ratio AOD, 3000 RPM C6 converter, B&M Hammer shifter, Stifflers transmission crossmember & driveshaft safety loop, FPP aluminum driveshaft, FPP 3.31 gears, Cobra Trac-Lok differential, Moser 31 spline axles, '04 Cobra 4-disc brakes, '93 Cobra booster & M/C, 5-lug Bullitt wheels & 245/45R17 M/T Street Comp tires.

    Comment

    Working...
    X