If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.
I have an MSD Atomic LS that functions OK so far. The handheld programmer works fine. I attempted to install an aftermarket tach using the grey wire from the harness and could not get a signal to the tach. I installed an MSD 8920 tach adapter, as advised by a tech, and still could not get a signal. I was wondering if anyone else had this problem, and possibly a solution?
