-
No, there's four ways to implement the odometer function ("Trans Speed", "GPS Speed", "Dash Speed", "ECU Input"). Read the LINK in post # 2 above. -
Bryant: I believe that the only way the odometer channel is available is if the speed signal comes in on the J4 (automatic transmission) connector. AndrewLeave a comment:
-
This is just for search reference. The Pro Dash is setup the same way as the Digital Dash for an Odometer/Speedometer: https://forums.holley.com/showthread...9568#post99568 (Related Forum Post)Leave a comment:
-
Digital Dash odometer with a GPS antenna?
I'd like to have an odometer on my 7" Digital Dash. I have searched through the menus on the Digital Dash, this forum, Google, and have not found a way to do it. I see how to videos on the Pro Dash, but those options do not come up on my 7" Digital Dash. In the 7" Digital Dash instructions on page 11, it mentions odometer, so that implies it should be available. https://documents.holley.com/199r10746rev1.pdf. I have the GPS antenna and a Terminator X ECU. How do I create an odometer gauge?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.
Leave a comment: