Tweet
I recently installed the 300-66 intake paired with the Holley 670 TBI. I’m having trouble with placement of a few things. First, the EGR valve will not fit, it hits the IAT. Second, the heater hose placement. The stock location on the 300-66 is a 5/16” port would this be sufficient or should I move to the larger one in the front. Lastly, vacuum lines location. Any help would be greatly appreciated.
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.