Announcement

Collapse
No announcement yet.

Pro Dash Custom Ohms Configuration.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Pro Dash Custom Ohms Configuration.

    I’m trying to configure a fuel level gauge on a 6.86” Pro Dash. The fuel sender is a 0-90 Ohm unit. When I select Custom Ohms on IO7 (pin 21) and go into settings, I can easily configure the Y-axis to display 0-100, but the X-axis reads “Ohms X 1000”. I'm unable to get it to just display “Ohms”. All values from 0-90 simply read 0 all along the X-axis, even after they're properly linearized in the table to the left. Any idea how I can remedy this? Thank you.

  • #2
    Just curious if you ever received an answer. I'm seeing the same thing.
    Last edited by John Bartos; 08-17-2022, 11:01 PM.

    Comment

    Working...
    X