Tweet
I recently purchased this system (Part # 20-242) for my new 502HO crate engine. While I was mocking everything up I notice that the diameter of the crank pulley (Part # 97-318) locating boss was .010” smaller than the inner diameter of the locating hole in the harmonic balancer. Normally these diameters are exactly the same to ensure the pulley is perfectly centered on the balancer. This prevents it from wobbling and causing destructive harmonics. Even though the pulley is held in place with three bolts, there is still too much play. Is there anything that can be done to fix this?
- If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. Please be aware that this is a community forum. Although Holley employees will take part in answering questions from time to time, your questions may or may not be answered by Holley personnel. Thus, Holley can not guarantee an answer or timing on an answer.